2011-2015 Jeep Wrangler AC Digital HID Kit

Jeep, 2011, 2012, 2013, 2015, 2014
 
$110.00
In stock
+
Add to wish list

Kit uses a H13 HX as seen below. It as a HID globe for the low beam and a small halogen bulb for the high beam. This is a much safer setup for the Jeep and works properly with the Canbus setup.

No one makes custom kits like us!!

This Kit not only improves the look of your Jeep, but increases visibility at night. Did you know that 60% of all traffic accidents take place in poorly lit conditions? Signs and road hazards can be seen from greater distance, but most of all you stand out to other drivers. H.I.D lights can be seen from over 100 feet further away than normal halogen bulbs.

H.I.D Bulb Life is over 10 times longer than halogen bulbs and consume about 45% less power.

Don't be fooled by other kits that claim to be plug and play. Since this kit is designed for the Wrangler, there is no wire cutting or modifications needed.

What is a Custom Kit?

A Custom kit is designed for a specific vehicle. The wire harness with relay is cut to specs and the directions are specific for that vehicle. Each Custom kit has a relay wire harness with circuit protection.

Why do you need a Relay Wire Harness?

Let's say you install the HID ballast directly to where the low beam halogen bulb is connected. Some vehicles might be are able to power up HID system normally without problems at install, but over time it will not last. Start-up current for HID Lights is 13 amps per ballast, compared to 7 amps for halogen.

Your factory wiring system is designed for a halogen based headlight which draws 7 amps of current at startup and 4.5 amps continuous load. Over time, connectors, multifunction switch, headlight switch, wiring and fuse holders will slowly degrade because of heat buildup. These components are very expensive to replace. This type of damage could have been avoided with a relay wire harness. With the relay harness power is drawn directly from your battery protecting your factory wiring and expensive ballast.


With our step by step instructions we show you the complete process from start to finish for the Wrangler.

*Kit offers one year warranty

What is Xenon Light?

The xenon bulb is a micro-discharge bulb filled with a mixture of primarily xenon gas and other inert gases, creating a superior , bright, white light. This special bulb has no filaments like a halogen bulb, but the light created between the two electrodes in a xenon bulb is like no other.

What are the advantages of Xenon Light?

The xenon bulb outputs more than three times the brightness that a halogen light, while consuming almost half the power (wattage).

Cost-wise , the life span of the xenon bulb lasts the life of the car under normal conditions. Bottom line, exceptional bright light, less power consumed, and great looks

Included in this kit you get the following:

  • 2 H13 HX Bulbs available in 4300k, 6000k, or 8000k, 10000k, 12000k. see picture below for image!
  • 2 Slim Digital Ballast
  • 1 Custom Wiring Harness with relay and circuit protection module
  • Xenon Canceller (Anti-flicker device)
  • Zip Ties
  • Website Link to Step By Step Instructions with Color Pictures


Year:
  • 2011
  • 2012
  • 2013
  • 2014
  • 2015